ClearPix CFB22DN-H2 Guide d'installation Page 15
- Page / 23
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
7
Cable Connections
Connecting Power
NOTE: Do not perform this procedure if Power over Ethernet (POE) is
used.
If PoE is not available, the encoder needs to be powered through the
removable power connector block. Refer to the diagrams in this guide
for the location of the power connector block.
The device can be powered from 12 VDC or 24 VAC. The power
consumption information is listed in the product specifications.
To connect power to the power connector block, complete the
following steps:
1. Remove the power connector block from the device.
2. Remove the insulation from ¼” (6 mm) of the power wires.
Do not nick or damage the wires.
3. Insert the two power wires into the two terminals on the
power connector block. The connection can be made with
either polarity.
Use a small slotted (5/64” or 2 mm blade width)
screwdriver to loosen and tighten the terminals.
4. Attach the power connector block back into the receptacle
on the device.
Warning — This product is intended to be supplied by a UL
Listed Power Unit marked “Class 2” or “LPS” or “Limited
Power Source” with output rated 12 VDC or 24 VAC, 8 W
min. or PoE rated 48 VDC, 8 W min.
- Installation Guide 1
- Important Safety Information 3
- Regulator Notices 5
- Other Notices 6
- Table of Contents 7
- Overview 9
- Rear View 10
- Installation 11
- Connecting Cables 12
- Assigning an IP Address 13
- Cable Connections 15
- 123456 7891011 12 16
- RS485 Device 16
- Audio IN 17
- LED Indicators 18
- Firmware Revert 19
- Setting the IP Address 20
- Through the ARP/Ping Method 20
- Specifications 21
Produits connexes et manuels pour Caméras de sécurité ClearPix CFB22DN-H2
(22 pages)LG 47LF65 manuels
Manuels d'utilisation et guides de l'utilisateur pour TV LCD LG 47LF65.
Nous fournissons des manuels en pdf 3 LG 47LF65 à télécharger gratuitement par type de document : Manuel de l'utilisateur
Commentaires sur ces manuels