ClearPix FB22DN-H2 Guide d'installation télécharger pdf (Page 19)

Reset to Factory Default

Settings

If the camera no longer functions as expected, you can choose to

restore the camera to its factory default settings.

Use the firmware revert button to reset the camera.

Figure: The firmware revert microswitch on the rear of the camera.

1. Disconnect power from the camera.

2. Using a straightened paperclip or similar tool, gently press

and hold the firmware revert microswitch.

3. While continuing to hold the microswitch, power the

device. Release the microswitch after three seconds.

Caution — Do not apply excessive force. Inserting the tool

too far will damage the device.

Firmware Revert Button

1 2 ... 14 15 16 17 18 19 20 21 22

Pas de commentaire

ClearPix FB22DN-H2 Guide d'installation Page 19